Points
of Interest:
-
Our storage drawers have been designed to be as strong and as light as possible. This is achieved by constructing the drawers from marine bonded plywood then re-enforcing any areas that are highly stressed with steel components. Some parts are glued screwed and braced, other parts are riveted or bolted together. Click here for more information on the construction.
-
Designed
individually to suit the VE, neatly following the contours of the vehicle.
Our drawers are designed to utilise all the space available.
Our
drawer systems are not designed to be continually exposed to the weather, they
should only be fitted to a utility with a canopy or some permanent cover fitted.
-
Fits the vehicle without drilling any holes. At the back of the ute tub there are two holes in the body. These holes are utilised for two mounting bolts. At the front of the tub (behind the cabin), the drawer system is held in place by a header board that locks into part of the steel body (see photos). If fitting a two drawer system one of the tail gate latches must be temporarily removed to allow enough room to slide the second drawer box into position.
-
Suits
a vehicle with a genuine ute liner.
Full
drawer system (two drawers "side
by side") $2700 + options,
half drawer system (one drawer) $1350 + options.
The internal dimensions for each drawer are: 1760mm(L) 495mm(W)
234mm(H) (These measurements are for our standard size drawer
system. The height of each drawer can be changed to suit the
customer)
