Points of Interest

• Our storage drawers have been designed to be as strong and as light as possible. This is achieved by constructing the drawers from marine bonded plywood then re-enforcing any areas that are highly stressed with steel components. Some parts are glued screwed and braced, other parts are riveted or bolted together. Click here for more information on the construction.
• Designed individually to suit the Landcruiser, neatly following the contours of the vehicle. Our drawers are designed to utilise all the space available.
• Fits the vehicle without drilling any holes by utilising four seat mount captive nuts in the cargo area.
• If required, a full Milford cargo barrier can be fitted in front of this system.
• We can build a drawer system for the Landcruiser at wheel arch height (240mm) or 300mm high.
• A bed extension is also available for this model.

Full drawer system (standard height) (two drawers "side by side") $2220 + options, half drawer system (one drawer) $1110 + options. The internal dimensions for each drawer are: 900mm(L) 440mm(W) 175mm (H) (These measurements are for our standard size drawer system. The height of each drawer can be changed to suit the customer)
Full drawer system (300mm high) (two drawers "side by side") $2300 + options, half drawer system (one drawer) $1150 + options. The internal dimensions for the 300mm high drawers are: 873mm(L) 440mm(W) 253mm (H)

FITTING INSTRUCTIONS:

Step 1. If the vehicle is fitted with third row passenger seats in the cargo area, remove the seats, the child restraint fitting, the seat mounts and the seat belts.

Step 2. Four of the "seat mount" captive nuts will be utilised to mount the drawer system. Replace the threaded screws into the remaining thirteen captive nuts to seal off the cargo floor.

Step 3. There is a plywood packer screwed onto the base at the front of each drawer unit. If the vehicle is fitted with a cargo barrier, in some cases these two packers are not required. If the vehicle does not have a cargo barrier, leave the packers in place.

Step 4. The top of this drawer system (the false floor) is in two sections. Unscrew each of these sections and remove them from the drawer units. If the drawer system has a built in fridge slide, only remove half of the false floor - i.e. remove the false floor on the opposite side to the fridge slide.

Step 5. Place the drawer units in the vehicle without the false floor and the side fillers attached. Align the mounting holes in the drawer units with the four "seat mount" captive nuts.

Step 6.Open the fitting kit. Join the two drawer units together using the six 35mm x 6mm threaded screws, nuts and washers provided in the fitting kit - the holes are drilled. (If the drawer system has a built in fridge slide there are only five threaded screws. Three 30mm x 6mm and two 35mm x 6mm).

Step 7. Fix the drawer units into position using the four 40mm x 10mm threaded screws and washers provided in the fitting kit. Do not overtighten these threaded screws.

Step 8. Attach the two side fillers using the black panhead screws provided in the fitting kit.

Step 9. Place the false floor tops in position then screw them back onto the drawer units.