Fitting
Instructions: This glove box has been
designed to fit a GU Patrol without a passenger's side air bag. The GU has a removable
panel attached to the dashboard directly above the genuine glove box. This panel
is converted into a glovebox door for the after market glove box. A hole must
be cut in the dashboard behind the panel to allow access to the aftermarket glove
box. STEP
1. Remove the genuine glove box then remove the six screws that hold the dashboard
panel in place. STEP
2. Using the template supplied, mark out the
area behind the dashboard panel that must be cut out. STEP
3. Using a hacksaw blade or similar, cut a section
out of the plastic dashboard, cutting on the lines marked out in step 2. Clean
up any rough edges with a steel file.
 STEP
4. There is now a steel bracketexposed below
the new hole in the dashboard. As shown in the photograph, attach this steel bracket
onto the plastic dashboard using the two large pop rivets supplied in the fitting
kit.
STEP
5. Included in your glove box kit are four pieces
of self adhesive velcro tape.As shown in the photograph, attach this tape around
the edges of the hole to obtain a neat finish. STEP
6. Using the seven small pop rivets and seven
of the washers supplied in the fitting kit, attach the piano hinge onto the base
of the dashboard panel. The photographs show where to fit the hinge - note the
position of the hinge knuckle.
STEP
7. As indicated in the photograph, trim 4mm off
the top of three of the plastic lugs inside the dashboard panel. 
STEP
8. Fit the glove box assembly into position.
The plywood base sits underneath the steel tube inside the dashboard. STEP
9. Drill two 1/8" dia holes into the steel
tube in line with the two holes in the base of the glove box insert. Attach the
glove box insert to the steel tube using two of the 25mm screws and the two large
washers, supplied in the fitting kit. STEP
10. Drill a 1/8" dia hole into the front
edge of the glove box insert in line with the hole in the dashboard (see arrow
on photograph). Attach the glove box to the dashboard using the remaining 25mm
screw in the fitting kit. STEP
11. Place the dashboard panel back into its original
position. Do not remove the foam rubber strip that is fitted around the outside
edge of this panel. The rubber strip is used to hold the panel in the closed position. STEP
12. Position the unattached piano hinge flap
flush against the dashboard. Make sure the dashboard panel is sitting square and
flush to the dashboard. Drill seven ?" dia holes into the dashboard in line
with the holes in the piano hinge. STEP
13. Attach the piano hinge to the dashboard using
the seven longest pop rivets, seven snap caps, and fourteen washers supplied in
the fitting kit. For each pop rivet, place one washer inside the snap cap and
one washer inside the dashboard. 
N.B.
Some customers prefer to leave the snap caps off leaving the head of the pop rivet
exposed. From a seated position, the piano hinge and rivet heads are not visible,
however the snap caps are visible. 
STEP
14. A black strap has been supplied to make it
easy to open your new glove box door. Attach this strap using one of the genuine
screws off the dashboard panel. | 
