Department of the interior, Department of the Car Interior, Console Supplies, 4wd Storage Drawers, Storage Drawers, car interiors, centre roof console, custom built console, floor console, roof console, overhead console, 4wd shelf
         
Asia Motors
Hino
International
Kia
Lada Niva
Landrover
Mack
MG
Morris
Oka Motors
Peugeot
Porsche
Renault
Rocsta
Saab
Ssangyong

Subaru

Suzuki
Toyota
UD
Volkswagen


       

 

You are in Products -> Nissan & Datsun -> GU Patrol Stationwagon -> Centre Floor Compartments With Tray (DX Model Only)

 




With tray
Compartment with tray and radio facia

With can holders and tray

 

Compartment with tray from $580

Compartment with can holders and tray $684

Compartment with tray and radio facia $620

 

Click here for prices of accessories and options.

Points of interest:

  • Upholstered in a vinyl finish to match the vehicle's interior.
  • Comes complete with a storage bin and a hinged padded lid. The storage bin is upholstered on the inside and includes a removable lining that is held in place by Velcro tape.
  • Designed to neatly fit the floorpan, butting up to the genuine plastic gear surround.
  • Robust construction - strong enough to sit on.
  • The compartment is fitted to the vehicle without drilling any holes. There are several genuine threaded screws fitted to captive nuts under the floor coverings between the seats. The compartment is fitted by utilising two of these captive nuts. Fitting instructions and a fitting kit are included.
  • The console can be set up with two large cup holders in the facia (see photo).
  • We manufacture our consoles in weekly batches. If we receive an order by Monday 5:30pm Sydney time your console will be dispatched on the following Friday. The dispatch date can vary if there is a public holiday.

FITTING INSTRUCTIONS

Introduction.The GU Patrol compartment is fitted to the vehicle without drilling any holes.There are several genuine threaded screws fitted to captive nuts under the floor coverings between the seats. The compartment is fitted by utilising two of these captive nuts.

STEP 1. Remove the genuine handbrake cover (ie. the plastic surround and the vinyl boot)

STEP 2. Remove the Velcro mounted lining from inside the floor compartment.

STEP 3. Place the floor compartment into position between the front bucket seats.The compartment should neatly fit the shape of the back of the plastic gear lever surround, and should neatly follow the contours of the floorpan. The compartment should be centred between the seats.

STEP 4. Using a marker pen, mark out onto the floor mat, the position of the two holes in the compartment mounting brackets.

STEP 5. Remove the compartment from the vehicle and make sure that your marks on the floor mat are in line with the heads of two threaded screws.

STEP 6. Using a sharp knife, cut a piece out of the floor mat and underfelt to allow access to the two threaded screws.

STEP 7. Remove the two threaded screws from the captive nuts in the floorpan. (these two screws are now discarded)

STEP 8. Open the "console fitting kit". Two longer threaded screws have been provided to mount the floor compartment.

STEP 9. Place the compartment back into position in the vehicle. Using the two threaded screws and washers supplied, attach the console to the vehicle.

STEP 10. Replace the Velcro mounted lining back inside the compartment.

STEP 11. Position the top of the handbrake boot at the base of the handbrake handle. Pull the leather lace tight around the handbrake handle, then tie a knot. Tuck any excess lace back inside the boot.