Across Windscreen Full Facia Roof Console from $390

Click here for prices of accessories and options.

A piece of "one wrap" hook and loop tape is supplied with each roof console (one retainer for each radio) to prevent your microphone curly cord from dangling and blocking your view. Simply screw this retainer onto the console in a suitable position between the radio and the microphone clip, then wrap the tape around the curly cord. If you need the full length of the curly cord, the "one wrap" tape is easy to release and re-attach.

FITTING INSTRUCTIONS:

Due to the lack of headroom and the wasted space above the hoodlining, the 110 roof console has been designed to fit the vehicle with the hoodlining cut down or with the hood lining completely removed.

Step 1. Remove the front hood lining. If you are fitting the console without the hoodlining go to step 5.

Step 2. Cut out the section of the moulded hood lining that fits around the rear vision mirror and fix it back into the vehicle under the mirror base.

Step 3. Peel the fabric cover off the front of the hood lining, then cut the hood lining as indicated in figure 1. Leave enough fabric overlap to tuck under the console facia and sides.

Step 4. Fit the hoodlining back into position. It may be necessary to glue some sections of the fabric overlap to the turret to support the hoodling.

Step 5. There is a recess cut on each side of the console base to accept the two steel brackets supplied. Hold the console in position and using a pencil, mark where each recess lines up with the channels above the doors. Remove the console, attach the steel brackets to the channel using the 12mm screws supplied. Re-fit the console and bend the brackets under the console. Screw the brackets to the console using the 25mm screws and snap caps supplied. Attach the console above the windscreen using the four 40mm screws and snap caps supplied.

In order to get maximum space in the facia panel, the cut
in the hood lining does not line up with the console facia.
There will be an approximate 2" gap as indicated in figure 2.