|
FITTING INSTRUCTIONS:
Step 1. Remove the console fitting
kit from inside the console.
Step 2. Unscrew one side of
each sunvisor - the side closest to the rear view mirror.
Step 3. Remove the front threaded
screw that holds the passenger's side grab handle onto the
vehicle.
Step 4. On the driver's side
of the vehicle there are two captive nuts under the hoodlining
for a driver's side grab handle. Puncture a hole through the
hoodlining where it covers the front captive nut.
Step 5. Without attaching the
sunvisor feet. Place the console in position and replace the
sunvisor screws back into the vehicle to bend the consoles
front mounting brackets into the correct shape.
NOTE:
Before fitting the console take note of the positions of the
sunvisor's foot locating pin hole and the screw hole. Be careful
not to fit the screw into the locating pin hole.
Step 6. Remove the sunvisor screws and the console.
Step 7. Install the wiring for
the radio(s) or accessories.
Step 8. Attach your radio(s)
or accessories onto the top of the console using the mounting
kits supplied with those units.
Step 9. Place the console in
position and secure it by replacing the passenger's side grab
handle and by attaching the 6mm x 20mm threaded screw supplied
in the "console fitting kit" to the driver's side
captive nut. Lift the front of the console into position and
secure it by reattaching the sunvisor mounting feet.
Step 10. Place a snap cap over
the head of the driver's side threaded screw.
|
