| Points
of interest: - Available
in a large range of colours. The most popular colours are Toyota chocolate brown,
dark grey and 70 tan.
- Robust
construction - suitably durable for offroad driving. Manufactured from steel and hardwood plywood - NO PLASTIC.
- Fits
the vehicle without drilling any holes by utilising the grab handle captive nuts
and sunvisor mounting screws.
- Installation
is quick and easy, fitting instructions and a fitting kit are included.
- Sits
high enough to provide maximum headroom and to allow the sungvisors to remain
in their original position.
- Holes for radios, map lights, storage etc. can be cut to suit your requirements.
- Designed so the radio curly cords are out of view.
- We
manufacture our consoles in weekly batches. If we receive an order by Monday 5:30pm
Sydney time your console will be dispatched on the following Friday. The dispatch
date can vary if there is a public holiday.
- Professional fitting service available.
FITTING INSTRUCTIONS: Introduction.
This console can be fitted to the vehicle without drilling any holes. The two
self tapping screws and snap caps supplied in the "console fitting kit"
are fitted through two holes at the front corners of the console into the body
of the vehicle. These screws are only required in extreme cases, when the console
is required to carry a large number of radios or heavy equipment. In most cases
the console can be fitted by utilising the sunvisor mounting screws and the grab
handle captive nuts. Step 1. Remove
the console fitting kit from inside the console. Step
2. Unscrew one side of each sunvisor - the side closest to the rear view mirror. Step
3. Remove the front threaded screw that holds the passenger's side grab handle
onto the vehicle. Step 4. Remove the
front Christmas tree plug that covers the front captive nut for a driver's side
grab handle. Step 5. Without attaching
the sunvisor feet. Place the console in position and replace the sunvisor screws
back into the vehicle to bend the consoles front mounting brackets into the correct
shape. NOTE:
Before
fitting the console take note of the positions of the sunvisor's foot locating
pin hole and the screw hole. Be careful not to fit the screw into the locating
pin hole.
Step 6. Remove the sunvisor
screws and the console. Step 7. If the
additional support of the two self tapping screws is required, (see introduction)
puncture two holes in the trim under the plywood holes at the front corners of
the console. Step 8. Install the wiring
for the radio(s) or accessories. Step 9.
Install your radio(s) or accessories into the console - see "instructions
for fitting a radio or accessories into the console". Step
10. Place the console in position and secure it by replacing the passenger's
side grab handle and by attaching the 6mm x 20mm threaded screw supplied in the
"console fitting kit" to the driver's side captive nut. Lift the front
of the console into position and secure it by re-attaching the sunvisor mounting
feet. Step 11. Place a snap cap over
the head of the driver's side threaded screw. | 
