Car Consoles & 4WD Storage Drawers - Department of the Interior - overhead consoles, roof consoles, custom built consoles, 4WD interiors, storage systems, vehicle consoles, radio console, dashboard pod, four wheel drive.

You are in Products -> Toyota -> Landcruiser 79 Series & 70 Series TDV8 cab chassis, utility and trayback -> Centre Floor Compartments

This photo shows a compartment that has been designed to butt up to a "U" shaped floor tray. Suits all models to and including June 2009.

Compartment with plain facia $495

Compartment with two can holders $559

Compartment with deep pocket in facia $550

Click here for prices of accessories and options.

NOTE: 1. This compartment will only fit a vehicle with two front bucket seats.
2. When our centre compartment is fitted, the passenger's seat belt stalk prevents the passenger's seat from sliding all the way forward. Most people find this limited amount of adjustment acceptable because the seat can be pushed forward part way and folded down to allow access behind the seats. To overcome this, we can supply a seat belt buckle made from webbing (cost $45 incl. GST).

Points of interest:

• This compartment will only fit a vehicle with two bucket seats.
• The versatile flat facia panel can house radio(s), can holders, a shallow tray or a deep pocket.
• Available in a large range of colours. The most popular - dark grey and tan.
• Comes complete with a storage bin and a hinged padded lid. The storage bin is upholstered on the inside and includes a removable lining that is held in place by velcro tape. (click here for more information)
• Designed to neatly fit the floorpan.
• This console is recessed on the driver's side to fit around the handbrake.
• This console can be built with a round front or a flat front. The flat front is designed to butt up to our floor tray (see photo).
• This compartment can be built with a round front or a flat front. The flat front is designed to butt up to our floor tray (see photo) - the flat front compartment and the “U” tray are only available for the early model with the steel dash (i.e. built date up to & incl. June 2009).
• Robust construction - strong enough to sit on. Manufactured from steel and hardwood plywood - NO PLASTIC.
• Installation is quick and easy, fitting instructions and a fitting kit are included.
• We manufacture our consoles in weekly batches. If we receive an order by Monday 5:30pm Sydney time your console will be dispatched on the following Friday. The dispatch date can vary if there is a public holiday.
• Professional fitting service available.

Fitting Instructions:

1) Remove the velcro mounted lining

2) Sit the compartment in position, so that the base of the console is a perfect fit, following the contours of the floor pan. Centre the compartment between the seats.

3) Drill two 9/64" diameter holes into the floorpan in line with the outside hole in each of the two angle brackets attched to the inside of the console.

4) Attach the console to the floor using the two 25mm self tapping screws supplied in the fitting kit.

Information required when ordering:

1) What type or brand of bucket seats are fitted to the vehicle?

2) What is the distance between the seats behind the handbrake (at the closest point)?

3) Do the seats have tilt dials and/or armrests between the seats?

4) Apart from the bucket seats, are there any modifications to the vehicle that could prevent the console fitting correctly? If yes, please email/phone us with the complete details. We will contact you if the modifications will cause any problems.

5) When manufactured, was the vehicle a three seater, or a two seater?

6) Any options/accessories required in the facia panel.

7) Which vinyl colour would you like your compartment upholstered in. Most of our customers prefer to match the colour of the floor covering or the original seats which were either tan, or dark grey.

8) Do you require the replacement passenger's side seat belt buckle.