Across Windscreen Shelf Roof Console from $420

Click here for prices of accessories and options.

Points of Interest:

• Upholstered in a vinyl or velour finish. The most popular — light grey, dark grey and tan.
• Robust construction — suitably durable for “off road” driving. Manufactured from steel and hardwood plywood - NO PLASTIC.
• Fits the vehicle without drilling any holes by utilising the grab handle captive nuts and sunvisor mounting screws.
• Installation is quick and easy, fitting instructions and a fitting kit are included.
• Sits high enough to provide maximum headroom and to allow the sunvisors to remain in their original position.
• We manufacture our consoles in weekly batches. If we receive an order by Monday 5:30pm Sydney time your console will be dispatched on the following Friday. The dispatch date can vary if there is a public holiday.
• Professional fitting service available.

FITTING INSTRUCTIONS:

Introduction. This console can be fitted to the vehicle without drilling any holes. It is fitted by utilising the sun visor mounting screws and the grab handle captive nuts.

Step 1. Remove the console fitting kit from inside the console.

Step 2. Unscrew one side of each sunvisor - the side closest to the rear view mirror.

Step 3. Remove the front threaded screw that holds the passenger's side grab handle onto the vehicle.

Step 4. Remove the front Christmas tree plug that covers the front captive nut for a driver's side grab handle.

Step 5. Without attaching the sunvisor feet. Place the console in position and replace the sunvisor screws back into the vehicle to bend the consoles front mounting brackets into the correct shape.

NOTE:
Before fitting the console take note of the positions of the sunvisor's foot locating pin hole and the screw hole. Be careful not to fit the screw into the locating pin hole.

Step 6. Remove the sunvisor screws and the console.

Step 7. Install the wiring for the radio(s) or accessories.

Step 8. Install your radio(s) or accessories into the console - see "instructions for fitting a radio or accessories into the console".

Step 9. Secure the console on the driver's side by fitting the threaded screw with the snap cap washer. Secure the console on the passenger's side by re-attaching the grab handle using the remaining threaded screw in the fitting kit. Lift the front of the console into position and secure it by replacing the sun visor mounting feet.

Step 10. Place the snap cap over the head of the driver's side threaded screw.